Stu's Rusty Bucket

Monday, July 28, 2008

Not a huge achievement but its a step

Right now I’m trying to fully parse the device tree so I can leave OF and jump into AROS.
The next step is to write the MPC5200 SOC drivers AROS needs (scheduler, mmu, timer, etc)

(The relevant bit is at the bottom of the boot message)

EFIKA 5K2 Boot Strap [RELEASE BUILD] (c) 2002-2007 bplan GmbH (BUILD 20070122 84240)
Running on    CPU PVR: 0x80822014
Running on system SVR: 0x80110022
BIOS Code position: 0xFFF040D0
Setup System Config…                                                 Done.
Setup Memory Config…                                                 Done.
Setup PCI…                                                           Done.
Setup ATA…                                                           Done.
Setup USB…                                                           Done.
Setup ETH…                                                           Done.
Setup AC97…                                                          Done.
Testing 08000000 Bytes, Pass: 00000000 Failed: 00000000
RAM TEST (fill random)…                                              Done.
cpu0: PowerPC,G2 CPUClock 396 Mhz BUSClock 132 Mhz (Version 0x8082,0x2014)
channel 0 unit 0 :   ata | ST920217A                                | 3.01    
ATA device not present or not responding
EMULATION INT HANDLER ENTERED WITH:
INT NO: 15

EAX=0003 EBX=1111 ECX=2222 EDX=3333 ESP=0000 EBP=5555 ESI=6666 EDI=7777
 AX=4E08  BX=C405  CX=0003  DX=102A  SP=6C1C  BP=5555  SI=5C6B  DI=7777
 DS=C000  ES=BAD0  SS=C000  CS=F000  IP=FE15   NV UP -- PL ZR NA PE NC
CS:IP = F4   FS=BAD4  GS=BAD5C4CA C000 0244 3000 0000 01B4 ABD5 0200 
UNHANDLED INT 10 FUNCTION 0007 WITHIN EMULATION
VM using 1657003 x86 cycles for GFX init
Welcome to SmartFirmware(tm) for bplan EFIKA5K2
Version 1.3 (20070122084838)
SmartFirmware(tm) Copyright 1996-2001 by CodeGen, Inc.
All Rights Reserved.
Pegasos BIOS Extensions Copyright 2001-2007 by bplan GmbH.
All Rights Reserved.
ok boot eth:0192.168.0.102 loader

** EFIKA Init **
BOARD : EFIKA5K2, revision 2B3
OpenFirmware : 1.3, 20070122
CPU : Version 0x8082 (Revision 0x2014), v2.2, 396 MHz (Bus 132 MHz) 
MBAR is at 0xF0000000
scanning memory:
    block 0 - 131072kb at 0x00000000
    block 1 - 16kb at 0xF0008000
Memory : 128MB
RTAS : base 0x7ffb000, entry 0x7ffb000, size=0x43bc


** OUT **